Feed Performance Computing Form

Values ​​of the displayed performance graph and performance table
may not be satisfied due to the load on the feeder due to material stress etc.

Input basic conditions ...

Model :
Feed Angle を指定
Feed Angle [deg] :
*Max 4 types ... Please enter in the range of 1~300.
Press Speed [spm] :
*Specify the range to be displayed.
Feedable Time を指定
Feedable Time [ms] :
*Specify the range to be displayed.

Enter optional conditions ...

Comparative Model :
Target Feed Length [mm] :

Model H25 Specifications

Max. Press Rotational Speed [spm] 700
Max. Feed Speed [mm/s] 1911

Required Release Operation Angle

Model H25 at 700spm
  1. The feed start angle and the feed end target angle (Overrun Check) setting are limited to 210 to 0 to 150 °. Therefore, the maximum feed angle that can be set is 300°.
  2. If you do not use press angle encoder, advance timing control of release timing according to press speed will be ineffective. Actual operation is delayed in Release Lag and Closing Lag time on the graph against the start / end timing of release by the cam signal.

Model H25 Performance Graph

Chart Manipulation Method
  • Double click : Zoom out.
  • Drag vertically or horizontally : Zoom specified area.
  • Hold down Shift key and drag : Move zoomed area.

X Axis :
Y Axis :

Model H25 Performance Table

Row Step Value

Press Speed
[spm]
Max. Feed Length[mm]
H25
150°180°210°
7006.711.317.2*
6807.312.318.6*
6608.013.320.1
6408.714.521.7
6209.515.823.6
60010.517.225.6
58011.518.827.9
56012.720.630.4
54014.022.633.3
52015.524.936.5
50017.227.540.1
48019.130.444.3
46021.433.849.0
44023.937.754.5
42026.942.160.7
40030.447.468.1
38034.553.576.6
36039.460.786.4
34045.269.497.3
32052.279.8109.6
30060.791.7123.6
28071.3105.4139.5
26084.4121.1157.9
24099.7139.5179.3
220117.8161.2204.7
200139.5187.3235.1
180166.0219.1272.2
160199.2259.0318.7
140241.9310.2378.4
120298.8378.4458.1
100378.4474.0569.6
80497.9617.4736.8
60697.0856.3999.9
40999.9999.9999.9
20999.9999.9999.9

・ * Mark: Depending on the start angle and acceleration of the press machine, the release operation may not be able to follow up.